How did you do? Show off your swiss darning with a community of crafters on Instagram and Facebook. This will make sure your design doesn’t come undone. ![]() Whenever you come to the end of a length of yarn, leave a tail of 6cm on the back of your work, and secure it with a knot, then weave the end into the stitches. Work your way along the rows and columns of stitches, following your pattern. Be careful not to pull your yarn too tightly, or you won’t be able to see your design clearly! Step 4Ĭomplete the stitch by inserting the needle through your starting point, and pull the yarn through. Step 4: Insert the yarn needle back through the base of the stitch, the same space as Step 1. Step 3: Pull the yarn through until the stitch lies flat and even with the rest of the fabric. Thread your needle under the 2 strands of yarn in the stitch above, and gently pull through. Step 2: Thread the yarn needle behind both legs of the stitch above the one you want to duplicate stitch over. A duplicate stitch is an embroidery technique used in knitting. So from where I put my pin on the middle of my basting line, I counted down ten knit V’s, and then started my duplicate stitch. The middle line of my heart was 20 boxes long. It is essentially duplicate stitch, but with no base fabric to work on. Bring your needle up through the base of the stitch from the back of your work, leaving a tail of about 6cm to weave in later. Plan for each square on your graph paper to be one knit stitch, or V, on your sweater. This darning method is most like knitting. This will be a knit stitch, which looks like a V shape, and you’ll begin at the bottom of the V. ![]() ![]() Thread your needle with an arm’s length of yarn - if you use a piece that’s too long, there’s a chance it might break or get tangled up while you’re sewing! Step 2įind your starting point using either a pattern chart, or your own design.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |